Basic Mallet with Bottle Opener

by TJHawke · February 27, 2025 tools · 4605 views · 981 downloads

Basic Mallet with Bottle Opener

Files

C2D design2.c2d

This is a mallet based on Will Adam's mallet design found here in CutRocket, but with the added feature of a bottle opener.

Notes

I used a Bosch 1/4" 2-flute endmill and a FOOS 1/4" 60 degree v-bit for the engraving. My speeds and feeds are probably a bit conservative, but I figure that I can override the speed while machining. My source material was a few free birch shipping spacers that I turned into a 1" thick board.