Bit holder tray
One of my first projects. It's a tray for a variety of bits in their boxes. Easy 'Push-to-Tilt' design allows easy access while keeping a low profile.
Design is for 3/4" MDF
Notes
Very straightforward. basic cutouts to fit most standard bit cases. a deeper cutout in the bottom 1/4 of each pocket means that pressing on the bottom makes the bit pop up to be easily grabbed.
Note: The one large pocket for the McFly should be a little shallower. It was paper thin and I glued a thin veneer to the bottom afterwards so that it wouldn't punch through (oops)