The first step is to Cut 5 x 1" x 4" x .75 pine into 31" lengths and glue them up to make a flat board.

Put the Panel onto the CNC machine and face the surface using a 1" or larger bit. Plane the surface smooth.

Then measure out the Union it is approximately 11.75" x 8.5". Stain this area Blue. Then stain the remaining area Red. Do not remove the piece from the CNC machine for this step. Let Dry.

Then CNC out the Circle for the LOGO.

Next CNC out the Stars and the Stripes.

Once the Stars, Stripes, and LOGO area are machined then use a torch and lightly torch the project. Then Spray with Clear Poly. Let Dry.

Once the Clearcoat is dry apply masking over the LOGO area. Now Carve out the LOGO. Once the Carving is complete it's ok to remove the piece from the CNC machine.

Once all the Carving is done clean up the Carves on the masking paper, Apply another Coat of Clear Poly onto the raw wood. Let Dry. Once dry mask off the RED and BLUE area, then paint the LOGO outline with BLACK spray paint. LET DRY.

Now carefully peal off all the masking tape and stain the logo to match the pictures or to your liking. LET DRY.

Do one final coat of Clear Coat. Let Dry and you are done.

Get creative as this is a VERY popular item.