Ima Rottin Tombstone
I made this tombstone for decorating the yard for Halloween. Cut out on a Foamular board from Menards. Tombstone shape came from https://elements.carbide3d.com/category/halloween/tombstone_2.svg/
Notes
Made using a 4x8 2" sheet Foamular. This design was done as a 12"x15" piece and cut on a Shapeoko XXL.
For bits I used
-RC-2243 1" spoilboard to clear out the main recessed in area quicker.
- 1/4" Endmill to make recessed area corners sharper (optional step)
- RC-1148 60 Degree V bit
- 1/4" Endmill to cut shape out. Mine was not long enough to cut 2" , needed to use jigsaw and clean up with flush trim router bit at router table.
Paints used
- Rustoleum bonding primer (not best choice, eats in to material but also gives weathered look)
- Rustoleum chalked aged gray ( was only gray paint store had, does provide nice contrast to primer though)