| Type | Length | Width | Thickness | Job Zero |
|---|
| Name | Type | Tool | Feedrate | Plungerate | Cut Depth |
|---|
| Filename | File Type | File Size | |
|---|---|---|---|
| design_1 | c2d | 12.48kB | |
| design_2 | c2d | 787.28kB |
I used solid maple planed down to 3/8". The 15 degree bevel was made by marking a line 1/2" up and sanding with a belt sander or with a table saw set at 15 degrees. I sanded with 150 and 220 grit sandpaper and then wet and dried both pieces to raise the grain and did final sanding with 320 grit. I sealed it with a 1:5 Beeswax/Mineral oil paste.
Have you made this project?
If so, upload a photo to show the author some love and let everyone know what your finished version looks like!
You must be signed in to upload a photo.
made by {makerusername}
Start the conversation!
You must be signed in to leave a comment.