This piece took a considerable amount of time to design and carve, I used 1/4 and 1/8 down-cut 2 flute flat end mills, 1/4, 1/8 and 1/16 ball mills for the beveling and went down to .8 mm for the small tool slots. The 2 sided operation used four 1/4 stainless pins for locating a tabbed frame on top of MDF. Everything is straight off the machine, with no finishing work needed, though there is a slight seam on the probe holder I missed due to a power outage, that I need to address with some sand paper.



Below is the Fusion web link for the downloadable full set including the USB Sega controller holder. If anyone wants to make this, just let me know I will tailor make tool-paths for your setup.