Date Created - 2020-07-19
Last Update - 2020-07-20 12:20:02
Status - published
I machined a lamp cover in polycarbonate to diffuse the light on my stove lamp. Perhaps it is useful for someone to have a look at the speeds and feeds or modelling of the pattern in fusion 360.
| Type | Length | Width | Thickness | Job Zero |
|---|
| Name | Type | Tool | Feedrate | Plungerate | Cut Depth |
|---|
| Filename | File Type | File Size |
|---|
If I machined this part again I would be mindful to not use tabs when cutting out the part as even though I sanded down those tabs they still left blemished that are quite visible when light is passing through the part.
It is also possible a 90 degree V-bit could cut the light diffusion pattern very fast instead of spending hours using ball end mill which is what I did.
Have you made this project?
If so, upload a photo to show the author some love and let everyone know what your finished version looks like!
You must be signed in to upload a photo.
made by {makerusername}
Start the conversation!
You must be signed in to leave a comment.