Setup Sheet
- Project Title: Interlaced 2x2 Spoil Board p2
- Designer: PwnCNC
- Project Source: Carbide Create
- Project udpated: 08/20/2020
Notes:
For a full size XXL, you'll need to make this 4 times.
There are 5 mounting grooves allowing you to secure the spoil board to the bed of your machine.
There are 3 carving groups within the design file...
- first is for carving the insert holes. I use a down-cut bit for the first to carves, with an up-cut when going through the board.
- second is for carving the top of the spoil board and carve out the 5 mounting grooves.
- third only needs to be done to the front right quadrant and cuts out a spot for the bit-setter to sit in the correct place.
Later I'll add an additional file for lasering a grid onto the top of your spoil board after surfacing.
